Proxmark3 community

Zombikiller

Contributor

Registered: 2024-08-29

Posts: 2

Friends - Help With Paxton Clone

Hi Friends,

Hope you are all well.

Could you please help with the steps/PM3 commands I need to use to clone the below card (to Hitag2) using my PM3?

Can you advise if the blocks/line needs wrote for all pages 0 > 11, or only some of the pages?

And does each line need wrote separately, or can a dump command be used?

Thanks kindly in advance

================================================

[usb] pm3 --> lf hitag read --21 -k BDF5E846
[+]  UID: 60958511

[=] Hitag2 tag information

[=] ------------------------------------
[+] Config byte : 0x06 [ 00000110 ]
[+] Encoding    : Manchester
[+] Version     : Hitag2
[+] Coding in HITAG 2 operation: manchester
[+] Tag is in   : Password mode
[+] Page 6,7    : RW
[+] Page 4,5    : RW
[+] Page 3      : RW
[+] Page 1,2    : RW
[=] ------------------------------------
[=] 00 | 60 95 85 11 | `...
[=] 01 | BD F5 E8 46 | ...F
[=] 02 | 20 F0 4F 4E |  .ON
[=] 03 | 06 F9 07 C2 | ....
[=] 04 | 9D 49 03 90 | .I..
[=] 05 | 08 BF 00 02 | ....
[=] 06 | 00 20 07 F5 | . ..
[=] 07 | A6 00 00 10 | ....
[=] 08 | 00 00 00 00 | ....
[=] 09 | 00 00 00 00 | ....
[=] 10 | 00 00 00 00 | ....
[=] 11 | 00 00 00 00 | ....

Last edited by Zombikiller (2024-11-21 22:49:45)