Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2021-03-29 00:33:24

bretzd
Contributor
Registered: 2021-03-28
Posts: 10

Problem setting up software

Hi everyone,

I wanted to set up the software for a proxmark3 easy but using "make clean && make all", leaves me with: Error 1 and 2 (from memset and memcpy). If I run the software and connect to the proxmark3 reading cards seems to work, only problem is I don't get any information which type of card is on the reader. Could this have to do with the problem above?

Changing the Makefile of the bootloader to:
APP_CFLAGS = -fno-builtin-I.
does not change anything

Thank you

Last edited by bretzd (2021-03-29 00:37:24)

Offline

#2 2021-03-31 23:40:36

bretzd
Contributor
Registered: 2021-03-28
Posts: 10

Re: Problem setting up software

Hi everyone,

getting the updated proxmark repo (2 days ago) from github solved the problem.

Memset and memcpy are errors from gcc10.

Offline

Board footer

Powered by FluxBB