Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2019-04-21 11:40:38

paranoidninja
Contributor
Registered: 2019-04-19
Posts: 2

[RDV4] Changes in power input during tuning and reading mode

Hello,

I am using proxmark3 for some of my my red team projects, and wanted to build an extremely small and a wireless portable version of the Proxmark3. I am using a Pizero W for this which starts up a Wifi hotspot on boot and takes up around 300-350Amps of power. I connected a 5v battery which outputs 1Amp to the Pizero and connected the Proxmark3 RDV 4.0 which I read that it takes up around 500 Amp of power. The pizero boots up fine and I can ssh via the hotspot and read LF/HF cards, but if I do HW tune, it reboots the PiZero. This only happens if I connect it to the battery. If I connect the pizero to a charger, it works fine coz my charger outputs around 2Amps which has led me to a conclusion that Hw Tune requires more power.

I haven't been able to test out the exact power requirements of the PM3, but I was wondering if anyone knows what is the power consumption of the PM3 and how much more power does it require. I have ordered a https://www.amazon.in/gp/product/B074JC3G4B/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 to check the power input, but that would take a few days to reach here and I was wondering if anyone could help me with the power consumption difference! smile

Offline

Board footer

Powered by FluxBB