Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2019-01-24 11:46:27

rmdashrf
Contributor
Registered: 2019-01-24
Posts: 2

Communicating with an e-passport

Hi again!

I'm having some issue trying to communicate with my RFID passport.

The only way I managed to get it to say something was to issue a raw command using hf 14b raw -c -p 05 00 08. hf search does not yield any results. Using the command above-mentioned, I managed to get what I think is its UID which it gives as part of the ISO14443 anti-collision protocol.

It seems like there is no apdu command for 14b, only for 14a. I believe that Proxmark's apdu is just a convenience command anyway and that it is possible to send and receive APDU messages just using the hf 14b raw command anyway.

My question is: how can I select my chip, and then send and receive ADPU messages, using the hf 14b raw command? I would have thought this would be a fairly obvious use case but I have been skimming through specifications and websites for days and I haven't managed to find the bytes I'm supposed to send anywhere...

Many thanks if you can help me,
rmdashrf

Last edited by rmdashrf (2019-01-24 11:47:03)

Offline

Board footer

Powered by FluxBB