Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Topic closed
#1 2020-01-12 02:10:19
- Knas
- Contributor
- Registered: 2020-01-12
- Posts: 5
Hello all and question
Saying hello here and have a few questions, I have been lurking on the community and various sites learning quite a lot about the proxmark III and am quite interested in purchasing it. I was wondering if anyone has experience using ProxBrute. I have read the paper and it seems like it is the only one available, it seems like I can flash proxbrute onto any proxmark but am I missing something? Is it really that easy? Another question was why is the hackerwarehouse version so much more expensive then say the Elechouse dev kit on Rsyc Corp. For someone who has minimal hardware knowledge and minimal software knowledge is the Elechouse a good option? It also says it is RDV2 while the hackerwarehoues version is RDV4, will this really matter? And does anyone have a Proxmark Pro from Rsyc? Maybe for someone who has minimal hardware and software knowledge the prebuilt ready to go Proxmark is best, although is it going to be a pain to get ProxBrute on it? Appreciate all help and am happy to be joining this form. I tried to do as much reading as possible before asking these questions.
Offline
#2 2020-01-12 06:55:41
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,506
- Website
Re: Hello all and question
Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.
Your access rights has been updated.
Offline
Pages: 1
Topic closed