Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
#1 2010-07-20 06:05:22
- wuninsu
- Member
- Registered: 2010-07-13
- Posts: 4
HELP ME!! My firmware is broken
I was updating my firmware into 412 version.
I must execute "prox fpga ..\armsrc\obj\fpgaimag.s19"
But I took a mistake. I did "prox bootrom ..\armsrc\obj\fpgaimage.s19"
After that, my PM3 does not work. If I connected it into my computer, all LEDs are on and never become off 
So, I tried to recover it.
I used JTAG connector and I connected my PM3 with it and using USB, I gave the power to the PM3.
I installed Win32-parallel-port-driver-95nt.exe and I connected it and I executed ArmPgm-Win32.
But when I click the check button, the message was "unable to stop it"
I know this means there is some error in my PM3 But I don't know what it is.
Please know me what makes this error and the way to solve it
Please reply it and if you have question, then reply it and I will answer your question Thank you~
Offline
Pages: 1