Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2022-05-18 07:41:44

chwan0409
Contributor
Registered: 2022-03-07
Posts: 3

proxmark rdv2 UART error while setting com state

I have a question while installing proxmark3 rdv2.
When I tried to run after checking the message that the installation was complete while flashing the firmware, the connection was not made and I tried to flash the firmware again.
However, the UART error while setting com state message appears and the time seconds continue to appear.
ex) 60[!] UART error while setting com state
I want to know how to solve it.
The environment used is window 10, port num 4.
The flash file port num is set to bar port 4.

Offline

Board footer

Powered by FluxBB